Teflon Tubing for 3D Printers - 1.75mm Filament, 1m Length
Estimated delivery between Wednesday, April 29th - Friday, May 1st
1 × ₵55.00
Subtotal:
₵55.00
Sensors, Modules & Shields
13.56Mhz RC522 MFRC-522 RFID Module
Availability:
50+ in stock
The RC522 is a 13.56MHz RFID module that is based on the MFRC522 controller from NXP semiconductors. The module can supports I2C, SPI and UART and normally is shipped with a RFID card and key fob. It is commonly used in attendance systems and other person/object identification applications.
₵28.00
50+ in stock
The RC522 is a 13.56MHz RFID module that is based on the MFRC522 controller from NXP semiconductors. The module can supports I2C, SPI and UART and normally is shipped with a RFID card and key fob. It is commonly used in attendance systems and other person/object identification applications.
RC522 Module Specifications:
- 13.56MHz RFID module
- Operating voltage: 2.5V to 3.3V
- Communication : SPI, I2C protocol, UART
- Maximum Data Rate: 10Mbps
- Read Range: 5cm
- Current Consumption: 13-26mA
- Power down mode consumption: 10uA (min)
Applications:
- Automatic billing systems
- Attendance systems
- Verification/Identification system
- Access control systems
Package Include:
13.56Mhz RC522 MFRC-522 RFID Module
Related products
-
Sensors, Modules & Shields
DHT22 temperature-humidity sensor
The DHT22 temperature-humidity sensor is an ultra-low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air and spits out a digital signal on the data pin (no analog input pins needed). It is fairly straightforward to use but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old
SKU: 1037 -
Sensors, Modules & Shields, Solar Products & Batteries
6volt-2watt solar panel module
6volt-2watt solar panel which can deliver up to 6V, 330mA. This solar panel is ideal for space-constrained applications where small voltage is required. When operating in sunlight or a bright artificial light environment, the optical energy will activate the solar cell and generate a voltage at the output. The panel is capable of 2watts in the open sun with a peak power output of around 6V at 330mA.
SKU: 1982 -
Sensors, Modules & Shields
MQ-2 Smoke Gas LPG Butane hydrogen Sensor Module
This semiconductor gas sensor detects the presence of combustible gas and smoke at concentrations from 300 to 10,000 ppm. The sensor’s simple analog voltage interface requires only one analog input pin from your microcontroller.
SKU: 1999 -
Sensors, Modules & Shields
DHT11 temperature-humidity sensor
The DHT11 temperature-humidity sensor is an ultra-low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air and spits out a digital signal on the data pin (no analog input pins needed). It is fairly straightforward to use but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old
SKU: 1034
